#Install cgminer on raspberry pi how to
#Install cgminer on raspberry pi serial
#Install cgminer on raspberry pi password

The following must be done under openwrt's root directory If you don't have an proper environment,you can try build-avalon-image.sh to get all you need for dev.

#Install cgminer on raspberry pi how to

You must have an openwrt development environment and know how to compile an firmware. How to maintain cgminer-openwrt-packages for avalon # cgminer -o :3333 -O xxxx:yyyy -D -verbose -api-allow 'W:0/0' -api-listen 2>/tmp/cgminer-debug.log If you use cgminer 4.5.0, the command will like this: If your avalon does not mine properly, please run Cgminer in debug mode with -D -verbose option. In case you need to run Cgminer in linux console please run the following command: change it to 32Д¤5: the controller timeout parameter. each modular have 8 miners), if your avalon have 4 modulars. this have to match the controller baud.Дў4: the miner count.(there are 3 modulars in avalon.

#Install cgminer on raspberry pi serial

here is the details:ДЎ15200: the serial baud. is the number is very low compare to others mean it is unhealth Cgminer option it is fixed 10 Frequency: Chip running frequcney Fan1/2/3: The fan speed round per minute Temp1: The air-in temperature Temp2/3: The air-out temperature DH(%): Hardwre error rate NMW: Non-match work count Firmware: the Openwrt firmware version Controller: The FPGA controller firmware version, 0: mean read nothing Cgminer API LOG page : the work matched to which miner. use ssh instead.Д¬gminer status page MinerCount: The small miner count, each modular have 8 miners AsicCount: The asic count on each miner.

#Install cgminer on raspberry pi password

Ssh # Once you setup the password the telnet service will be stop.

Check your avalon status: Status -> Cgminer Status.

Restart the cgminer service: System -> Startup,.

setup your mining worker: Status -> Cgminer Configuration.

Make sure WR703N can access Internet, Configure WiFi: Network -> WIFI -> Scan(select your WIFI network) -> Join Network -> WPA passphrase -> Submit -> Save & Apply for connect to WIFI Internet.

Setup your laptop IP address 192.168.0.101.

Connect your laptop to the eithernet port of the Avalon.

For 4 module units: 750W, 60A 12V, at least.

For 3 module units: 650W, 48A 12V, at least.

Enermax й‡‘й”е†°ж ё1000W(suit for 4 modules, a little bit long).

Machine power consumption: 595W 220V-AC / 620W 120V-AC Module power consumption: 149W 20GHs / 22GHs Power Chip power efficienty: 6.6W/GHs 1.15 V

9 How to Compile Your Own Firmware for AvalonДЄvalon Mini is a two module power house clocking the 110nm chips at 375Mhz, 595W.

6.5 How to maintain cgminer-openwrt-packages for avalon.